Everything about Knot Speed totally explained
Knot is a unit of speed, equal to one
nautical mile per hour.
The abbreviation preferred by maritime authorities in the USA, and Canada, as well as the
Institute of Electrical and Electronics Engineers and the
International Bureau of Weights and Measures is
kn.
The abbreviation
kt is also in widespread use, sometimes with
kts for the plural (knots). It is a non-
SI unit accepted for use with the
SI. The international definition was adopted by the UK in 1970 which previously used the UK or Admiralty nautical mile of 1853.184 m. This is the definition used in most, if not all, modern circumstances. A common error that should be avoided is to use the term 'knot' to refer to the nautical mile itself.
The speed of a vessel relative to the fluid in which it travels is usually measured in knots. This may be referred to as 'boat speed', 'vessel speed' and, for aircraft, '
air speed'. For consistency in navigation, the speed of relevant fluids, such as
tidal stream,
river current and
wind speed, is also usually specified in knots. Knots are then also used to describe the actual
speed of a vessel over the ground (SOG) and for its rate of progress toward a distant point ('
velocity made good' or VMG).
Origin
Until the mid-19th century vessel speed at sea was measured using a
chip log. This consisted of a wooden panel, weighted on one edge to float upright and thus have substantial water resistance, attached by line to a reel. The chip log was "cast" over the stern of the moving vessel and the line allowed to pay out.
Knots placed at a distance of 47
feet 3
inches (14.4018 m) passed through a sailor's fingers, while another sailor used a 30 second
sandglass (28 second sandglass is the current accepted timing) to time the operation. The knot count would be reported and used in the sailing master's
dead reckoning and
navigation. This method gives a value for the knot of 20.25 in/s, or 1.85166 km·h
−1. The difference from the modern definition is less than 0.02%.
Modern use
Although the unit "knots" doesn't fit within the primary SI system, its retention for nautical and aviation use is important for navigational reasons, since the length of a nautical mile is almost identical to a minute of
latitude. As a result, distance in nautical miles on a navigational chart can easily be measured by using dividers and the latitude indicators on the side of the chart.
Nautical speed is sometimes erroneously expressed as "knots per hour" which would actually be a measure of acceleration, as in "nautical miles per hour per hour."
Aeronautical terms
Prior to 1969, airworthiness standards for civil aircraft in the USA
Federal Aviation Regulations specified that distances were to be in statute miles, and speeds in miles per hour. In 1969 these standards were progressively amended to specify that distances were to be in nautical miles, and speeds in knots.
The following abbreviations are used to distinguish between various measurements of
airspeed.
Further Information
Get more info on 'Knot Speed'.
|
External Link Exchanges
Do you know how hard it is to get a link from a large encyclopaedia? Well we're different and will prove it. To get a link from us just add the following HTML to your site on a relevant page:
<a href="http://knot__speed.totallyexplained.com">Knot (speed) Totally Explained</a>
Then simply click through this link from your web page. Our crawlers will verify your link, extract the title of your web page and instantly add a link back to it. If you like you can remove the words Totally Explained and embed the link in article text.
As long as your link remains in place, we'll keep our link to you right here. Please play fair - our crawlers are watching. Your site must be closely related to this one's topic. Any kind of spamming, dubious practises or removing the link will result in your link from us being dropped and, potentially, your whole site being banned. |
